Retrotec USACE - Manual (Page 413)

Appendix L L13
4.4.5 Install secondary pumping systems.
4.4.6 Replace air conditioning and heating units with heat pumps.
4.4.7 Electric heater replacement on standby generators with a heat pump.
5 Lighting
5.1 Use daylighting or sky lighting with dual-glazed low-“e” glass.
5.2 Install dimming controls for areas close to windows.
5.3 Install dimming controls for areas with skylights.
5.4 Install high-effi ciency electronic ballasts.
5.5 Install high-pressure sodium lighting in selected areas.
5.6 Install LED exit signs.
5.7 Install LED traffi c signals.
5.8 Install low-pressure sodium lighting in selected areas.
5.9 Replace interior and exterior lighting.
5.10 Make lighting control improvements.
5.11 Install lighting for parking lots or athletic fi elds.
5.12 Use occupancy sensors (where applicable).
5.13 Reduce illumination levels.
5.14 Remove or replace lenses.
5.15 Replace all incandescent bulbs with compact fl uorescent.
5.16 Replace T12 fl uorescent lamps with high-effi ciency T8 systems.
5.17 Replace mercury vapor lamps with compact fl uorescent.
5.18 Use high-effi ciency fl uorescent lighting.
5.19 Use refl ectors to provide more effi cient lighting.
5.20 Use task lighting with low ambient illumination.
5.21 Use multiple switching for selected lighting levels in offi ces, conference rooms, and so
forth.
5.21 Use natural lighting in perimeter offi ce spaces.
5.22 Use timers and photocells for controlling outdoor lighting.
5.23 Recover heat from light systems.
5.24 Install skylights.
5.25 Rewire lighting and other systems to allow personnel to shut off sections of systems
rather than leave entire systems running.
5.26 Clean and maintain lighting systems.
5.27 Reduce operating hours for lighting systems.
5.28 Replace high bay metal halide to lamps with T8 or T5 Fluorescent High Bay Fixtures.
5.29 Use only local task lighting if possible.
5.30 Use reduced lighting levels for cleaning, nighttime, and security staff.
5.31 Switch off exterior security lighting during daylight hours.
5.32 Use “cutoff” fi xtures for outdoor lighting.