Toa D-2000 Series - Manual (Page 68)

68
(5) Gain indication button [Fader (dB)]
Displays the level for each channel by means of numerical values. If
you click this button, a dialog for fader setting is displayed, enabling
you to set the level by directly entering a numerical value.
Setting range: –∞, –69.9 to +10 dB
You can also change the gain in 0.1 dB units with the Up and Down
buttons located on the right side.
(6) Channel ON/OFF button [On/Off]
Displays the channel ON/OFF status of each channel. Click this button to turn on or off the channel.
(7) Channel number display
Displays each channel number.
(2)
(1)
(3)
Input, Bus, and Output VCA displays
Clicking the "VCA" on the display selection tab displays VCA levels set by the faders. VCA values controlled
by external equipment through VCA module settings are displayed. Unmodified VCA values are displayed as
is (10.0).
Note
VCA volume cannot be adjusted from a PC.
(1) Fader
Displays the fader. It cannot be changed.
(2) VCA values
Displays the VCA values controlled by external equipment through VCA module settings. Displayed values
cannot be changed.
(3) Channel number display
Displays each channel number.
(4) VCA operation indicator
Lights whenever any VCA fader points the VCA value other than "10.0" (through state).
(When the VCA is active)
(4)