Toa D-2000 Series - Manual (Page 131)

131
10.3. Connection Settings
Perform settings needed to communicate with the units in this section.
Settings such as network settings and unit ID settings can be made and the firmware version number can be
confirmed.
Step 1. Select "Communication Comm Setting..." from the menu.
Network settings of the units found on the network are displayed.
The table below shows the factory preset settings for each unit.
D-2008SP D-2012C
IP address 192.168.14.1 192.168.14.11
Subnet mask 255.255.255.0 255.255.255.0
Default gateway 0.0.0.0 0.0.0.0
4 5
2
6
3
If a unit's IP address is duplicated or inappropriate network setting has been performed, such device
is displayed in the "Unconnectable units" list.
If a D-2008SP is selected in the list, its front-mounted LAN DETECT indicator lights up.
• To change the unit's IP address setting, advance to Step 2.
• When transmitting the settings data changed in Step 2 to the unit, advance to Step 3.
• When changing the PC's network settings, change them from the Windows Control Panel. PC
network setting cannot be changed using the D-2000 software.
• When connecting to the unit via a router, network settings are not displayed on this screen. The unit
network settings cannot be changed. Connect such unit to a LAN and perform the network settings
in advance.
If no unit was detected:
Install the undetected unit within the reach of broadcast packet.
Communications may be interrupted when the PC is firewall-protected.