Toa D-2000 Series - Manual (Page 120)

120
Step 3. Make the fader/encoder related settings: unit ID, channel area, channel number, level meter position,
and fader knob color.
Press the button to set, then select the necessary item from the pop-up menu.
Note
A set of the unit ID, channel area, and channel number to be assigned to the faders and rotary
encoders cannot be duplicated in a single fader layer.
If duplicated, the corresponding channel box is displayed in a red frame.
Motorized fader/rotary encoder number
Unit ID
Channel area
Channel number
Level meter position
Fader knob color
Step 4. Perform settings for all faders and encoders.
Tips
• The fader/encoder setting data can be copied to the clipboard by holding down the Ctrl key and
pressing C key after selecting these boxes. The copied data can be pasted by holding down the Ctrl
key and pressing V key after selecting the target fader/encoder boxes.
• Multiple fader/encoder data boxes can be copied and pasted.
• Copy and paste is possible between units, and between fader layers.
Step 5. Click the "OK" button.
Setting is complete.
Note
If something is wrong with setting, the "OK" button cannot be clicked.