Toa D-2000 Series - Manual (Page 133)

133
Step 5. Delete the unit from the list.
Select the unit to be deleted, then click the "Delete" button.
The selected unit is deleted from the list.
Step 6. Click the "Next" button, then the Firmware version check screen is displayed.
• When the firmware version is older than that the D-2000 software supports, the unit is displayed in
the Uncontrollable units list.
• If a unit that does not need to be controlled is displayed, advance to Step 7 to delete it from the list.
• When updating the D-2008SP firmware, advance to Step 8 to execute data backup, then advance
to Step 9 to update the firmware.
• To update the D-2012C firmware, advance to Step 9.
• If all units to be controlled are shown in the Controllable units list, advance to Step 10.
Step 7. Delete the unit from the list.
Select the unit to be deleted, then click the "Delete" button.
The selected unit is deleted from the list.
Step 4. Add the unit to be connected via a router in a list. Clicking the "Add" button displays the "Add target
unit" screen. Enter the IP address of the added unit and click the "OK" button.
Note
Network setting for the unit to be connected via a router cannot be changed using the method
described in Step 2.
If you need to change the network setting, connect such unit to a LAN and change the network setting
in advance.