Toa D-2000 Series - Manual (Page 22)

22
Step 21. Click the "Next" button.
The X-over Combination screen is displayed.
Note
To set the crossover function, proceed to Step 22. Otherwise, proceed to Step 25 on
the next page .
Step 22. Click the setting contents to perform the crossover combination settings.
Setting status is displayed on the right side of the screen.
When "2-way" is selected on a channel, its next channel is used together.
When "3-way" is selected on a channel, its next 2 channels are used together.
When "4-way" is selected on a channel, its next 3 channels are used together.
Note
Performing the crossover combination settings causes 1 or 2 output filter points on the
corresponding channel to be used: 1 filter point is used when HPF or LPF is set, and 2 filter points
when BPF (both HPF and LPF) is set.
[2-way/2-channel setting example]