Toa D-2000 Series - Manual (Page 166)

166
14.2.3. Settings when the CobraNet module is used
Setting Item Setting Range Initial Value
Bundle 0 – 65279 0
Multicast bundle: 1 – 255
Unicast bundle: 256 – 65279
Latency and Bit Length 5.33 ms (20 bits), 2.67 ms (20 bits, 24 bits), 5.33 ms (20 bits)
1.33 ms (20 bits, 24 bits)
Conductor Priority 0 – 128 32
[Filter Settings]
Filter Type Setting Item Setting Range Initial Value
Parametric Equalizer Center frequency 20 Hz to 20 kHz, 1000 Hz
(PEQ) 1/24 octave steps
Gain –15 to +15 dB, 0 dB
(Boost/cut) 0.1 dB steps
Q 0.267 – 69.249 4.318
High-pass Filter Cutoff frequency 20 Hz to 20 kHz, 100 Hz
(HPF) 1/24 octave steps
Slope 6 dB/oct 12 dB/oct – – –
Q – – – 0.500 – 2.563 0.500
Low-pass Filter Cutoff frequency 20 Hz to 20 kHz, 10 kHz
(LPF) 1/24 octave steps
Slope 6 dB/oct 12 dB/oct – – –
Q – – – 0.500 – 2.563 0.500
High Shelving Filter Rolloff frequency 6 kHz to 20 kHz, 6 kHz
1/24 octave steps
Gain –15 to +15 dB, 0 dB
(Boost/cut) 0.1 dB steps
Low Shelving Filter Rolloff frequency 20 Hz to 500 Hz, 500 Hz
1/24 octave steps
Gain –15 to +15 dB, 0 dB
(Boost/cut) 0.1 dB steps
All Pass Filter Phase reversal 20 Hz to 20 kHz, 1 kHz
frequency 1/24 octave steps
Q 0.267 – 69.249 0.267
Notch Filter Center frequency 20 Hz to 20 kHz, 1 kHz
1/24 octave steps
Q 8.651 – 69.249 8.651
Horn Equalizer (Horn EQ) Gain 0 to +18 dB, 0 dB
0.5 dB steps
Note
The D-2000 Setting Software version 3.0.0 or
earlier allowed the parameters to be set to 0 –
255. Though using Parameters over 128 set
by this software version permits the unit to
operate, it is recommended to use Parameters
128 or less.