Toa D-2000 Series - Manual (Page 108)

108
[Function key settings]
Perform settings for the D-2012C's 8 function keys.
Clicking the Function Key Setting button located on the left side of the function keys causes the function key
setting screen to be displayed.
(1) Name
Set the name to be displayed above each
function key in the Console view.
(2) Function
Sets the function to be assigned to the function
keys.
The control target range by the function key
depends on the function assigned to the key.
For the control target range, refer to the table on
the next page .
Note
Each function of Memory Store, LED Control,
Key Lock, and Monitor Clear can be assigned to
only one of 8 function keys.
• Memory
Recalls the setting status stored in preset
memory.
The D-2012C's current setting status can be
stored in preset memory by clicking the function
key in combination with the function key
assigned to the memory storage function.
• Memory Store
Click the key in combination with the function
key assigned to the memory function.
• Line Input (D-936R or D-937SP must be
installed)
Switches the line (stereo) input of the D-936R
Stereo Input Module or D-937SP Digital Input
Module.
• LED Control
Turns off the D-2008SP's front panel-mounted
level indicator.
• Fader Layer
Recalls the channel assignment status stored
in the fader layer.
• Console Switch
Sets the contact output of the D-981 or D-983
Remote Control Module or the D-984VC VCA
Control Module installed in the D-2008SP to
ON.
• Key Lock
Enables and disables manual operation of the
D-2012C's motorized faders, function keys,
rotary encoders, etc.
• Monitor Clear
Clears the selection of channels to be
monitored.
• External Control Switch
Allows the D-2008SP with ID 1 to transmit the
function key ON/OFF data to an AMX or other
external control devices using external control
protocol. The external control device can
transmit the external control command to the D-
2008SP with ID 1, controlling its function key's
indicator ON or OFF.
• None
No function is assigned to the function key.
(3) Parameter
Set the preset memory number when a function
is set to "Memory," the module input line select
number when set to "Line Input" and the fader
layer number when set to "Fader Layer."
(4) Position
Selects the slot in which the D-936R or D-937SP
is inserted when a function is set to "Line Input."