Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) - Manual (Page 250)

250 Rockwell Automation Publication 7000-UM151E-EN-P - January 2013
Chapter 5 Drive Programming and Parameters
Pressing [F7] changes the displayed data format. When data appears as a mixture,
a particular value is displayed based on the priority defined above, (control
characters is highest).
The RX row displays data received by the operator interface. The TX row
displays the data transmitted by the operator interface.
Print Screen
The print screen operation creates a “screen dump” of the operator interface
display. This uses a second RS232 port communicating at 9600 baud to an
external computer. The receiving computer requires special software to receive
and interpret the data.
Call this function from any screen by pressing [F10] +
►
simultaneously. The
screen clears, and a message indicates that the interface is transmitting the screen
print, and the job progress. When complete, the original screen reappears.
Memory Dump
The memory dump enables you monitor any directly accessible memory (i.e.
memory that does not require access through a port). Call this function from any
screen (except PRINTER) by pressing [F10] +
◄
simultaneously.
Figure 245 - Data Segment Memory Dump
The initial screen, ( Figure 245 ) shows the data segment by default. Each screen
shows the current segment (in hex). The left column displays the starting address
(in hex) for that row of data, eight bytes of data (in hex), and the equivalent eight
ASCII characters (if relevant). Additional data within the segment is available by
pressing [F8] or [F9].