Loading language modules – Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) User Manual

Page 246

246

Rockwell Automation Publication 7000-UM151E-EN-P - January 2013

Chapter 5 Drive Programming and Parameters

You must use the filename extension “*.PAR” to indicate a parameter file. The file
format is:

• First Line:

– a revision number followed by a semi-colon (;). Number is not

important.

– the date followed by a semi-colon, i.e. 01/01/1996. Date is not

important.

– the time followed by a semi-colon, i.e. 12:01:01. Time is not important.

• Remaining Lines:

– each line contains one parameter, consisting of the linear parameter

number followed by a semi-colon, and the parameter value followed by
a semi-colon, as in these examples:
1;0;
2;0;
5;2;

Loading Language Modules

To use a language in the operator interface, load it into the operator interface
from the flash card.

From the TRANSFER screen, press [F5]. On the DIRECTORY screen, select or
enter an existing language module filename. Refer to

When you select a filename, the TRANSFER: LANGUAGE screen displays the
filename, the operation in progress, and showing the operation status.

Figure 238 - Language Directory

IMPORTANT To edit drive operations, you must have an access level above 'Monitor'.

Press [F8] and enter the appropriate PIN to access and modify drive
operations. Refer to

for more

information on access security.