Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) User Manual
Page 224
224
Rockwell Automation Publication 7000-UM151E-EN-P - January 2013
Chapter 5 Drive Programming and Parameters
The PLC setup consists of eight words of input and eight words of output,
appearing on separate screens, shown in
. Press [F8] to toggle between
INPUT and OUTPUT screens.
The layout of the PLC rack depends on DIP switch settings on the RIO adapter,
(refer to the appropriate manual for information on the following adapters and
their use: 1203-GD1, 1203-GK1, 1203-CN1, 1203-GD2, 1203-GK2, 1203-
GK5, 1203-GU6, 1203-SM1 and 1203-SSS). The drive assigns tags to rack
module locations in pairs (or “links”) that consist of two input and two output
words. You can assign a total of four links to the RIO adapter.
The screens show the current tags and tag codes associated with each link. To edit
a link tag, use
▲
or
▼
to select a link and press [Enter].
Selecting a Parameter on page 205
for more information on selecting
options. When selecting a tag for output words, only editable parameters appear.
Both parameters and read-only parameters appear for input words.
To remove an assignment for the selected link, press [Backspace].
XIO
The drive uses XIO adapters to hardwire to discrete inputs and outputs. Each
drive contains one or more of these modules, which has a unique address
according to where it attaches on the link. This address value appears on the
module’s LED display. Configure the drive with these address values to link them
to specific drive parameters.
To configure the XIO, select 'XIO' on the SETUP.
IMPORTANT To edit ANY parameter, you require an access level above 'Monitor'.
Press [F8] and enter the appropriate PIN to access and modify drive
parameters. Refer to
Configuring Access Levels on page 210
for more
information on access security.
IMPORTANT The interface does not implement new values until you exit the screen.
Prior to this you can modify the new value by repeating the above
procedure, or cancel by pressing [F7]. Cancelling returns the option to the
original value.
IMPORTANT This feature is currently inactive and is reserved for future
enhancements.