Language selection, Modify parameters, Language selection modify parameters – Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) User Manual
Page 214
![background image](/manuals/580207/214/background.png)
214
Rockwell Automation Publication 7000-UM151E-EN-P - January 2013
Chapter 5 Drive Programming and Parameters
Language Selection
The drive supports multiple languages. The operator interface supports these via
modules you must load from flash card (refer to
).
To select an alternate language, press [F9]from the SETUP screen to see a list of
currently-loaded language modules.
Figure 191 - Language listing
Each language also lists a revision level. Use
▲
or
▼
to select a language and press
[Enter]. The interface switches to the selected language.
Other devices attached to the drive may request a language change. If this occurs,
the operator interface will change languages if the required language module is
available.
Modify Parameters
To change a parameter, use
▲
or
▼
on the SETUP screen to select the
'Parameters' option and press [Enter]. You can also select a parameter from a
group on the DISPLAY screen (
) by pressing [F7].
The type of parameter you select determines the screen that follows.
IMPORTANT To edit ANY parameter, you must have an access level above 'Monitor'.
Press [F8] and enter the appropriate PIN to access and modify drive
parameters. Refer to
Configuring Access Levels on page 210
for more
information on access security.