Upload to operator interface, Download from operator interface – Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) User Manual
Page 244
244
Rockwell Automation Publication 7000-UM151E-EN-P - January 2013
Chapter 5 Drive Programming and Parameters
To transfer parameters, press [F4] from the TRANSFER screen. Within this
screen it is possible to perform four different parameter transfers.
Figure 235 - Transfer Parameters Menu
Upload to Operator Interface
Press [F5] to read parameters from the drive and upload them to the operator
interface. The screen prompts for confirmation. Press [F8] to proceed, or [F9] to
abort. Performing a “DRIVE TO MEMORY” transfer overwrites any previous
parameters stored within the operator interface.
Figure 236 - Transfer Stored Parameters
Download from Operator Interface
Press [F3] to download the parameters stored in the operator interface to the
drive. The screen will be similar to
, except the operation will show
“MEMORY TO DRIVE”. Press [F8] to confirm the operation, or [F9] to abort.
Performing a “MEMORY TO DRIVE” transfer overwrites the active parameters
in the drive, but does not affect the parameters stored in NVRAM.
After you download parameters, the screen prompts you permanently save the
new configuration. Refer to
for further details.