beautypg.com

Setting the trigger – Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - ForGe Control (PanelView 550) User Manual

Page 235

background image

Rockwell Automation Publication 7000-UM151E-EN-P - January 2013

235

Drive Programming and Parameters Chapter 5

When you have completed the selection process, the interface assigns the tag to
the trace, as shown below. To remove a tag from the highlighted trace, press
[Backspace].

Figure 224 - Assign a trace

Setting the Trigger

After assigning a tag to Trace 1, configure the trigger value by defining the
following:

• trigger type (press [F9])
• trigger condition (press [F2])
• trigger value (press [F3])

There are two types of triggers:

• single trigger: occurs once and stops; you must manually re-arm. (Default)
• continuous trigger: re-arms itself, continues to collect new trends until

viewing collected data stops it.

The interface indicates the current type of trigger as 'S' or 'C', prefixed to the
Trigger label (see

Figure 224

). To toggle types, press [F9].

Set the trigger condition and trigger value using [F2] and [F3] respectively.
Highlight any field to edit.

Set the condition to one of following options using

or

to scroll through the

list. Press [Enter] to accept the selected option.

Trigger Conditions:

=

Equal to

N=

Not equal to

>

Greater than

<

Less than

+

Boolean OR