JLG X23J - X700AJ Service Manual - Manual (Page 73)

SECTION 3 - CHASSIS & TURNTABLE
3-46 – JLG Lift – 3121448
PLACE THE BEARING (14) IN THE GEARBOX HOUSING (9) WITH
THE LAPPED SIDE UPWARDS.
Figure 3-123.
6. By using a press and a metal stopper, push the
bearing (14) against the gearbox housing shoulder
(9).
Figure 3-124.
Make ready of the lifetime seal:
Carefully clean the seats ("A" and "B") using, if necessary,
metal brushes or solvent (surfaces in contact with or ("C")
must be perfectly clean and dry).
Make sure that sealing surfaces "D" of metal rings "E" are
free from scratches, dinges or foreign substances; metal
ring surfaces must be perfectly clean and dry.
Carefully clean the lapped surface "D" of metal rings "E"
and remove dust or finger prints. Then lubrificate them
with a thin oil film, taking care not to oil the other compo-
nents.
Figure 3-125.
7. Fit the half seals (14) on the tool (ATZ.04.008.0).
Figure 3-126.