JLG X23J - X700AJ Service Manual - Manual (Page 207)

SECTION 3 - CHASSIS & TURNTABLE
3-180 – JLG Lift – 3121448
OVERRUNNING CLUTCH
Check the pinion gear shaft (1) for smooth axial move-
ment.
Apply oil or replace the overrunning clutch if necessary.
Check the pinion gear (2) operation by holding the pinion
gear shaft and turning the pinion gear. The pinion gear
should turn counterclockwise freely and should not turn
clockwise.
Check the pinion gear for wear or damage, and replace
the overrunning clutch if necessary.
If the pinion gear is worn or damaged, the flywheel ring
gear must be inspected.
STARTER SOLENOID WIRE
Check the starter solenoid wire for continuity.
(2)
(1)