JLG X23J - X700AJ Service Manual - Manual (Page 175)

SECTION 3 - CHASSIS & TURNTABLE
3-148 – JLG Lift – 3121448
CARBURETOR DISASSEMBLY/ASSEMBLY
Dual element or cyclone type air cleaner:
GASOLINE IS HIGHLY FLAMMABLE AND EXPLOSIVE.YOUCAN BE
BURNED OR SERIOUSLY INJURED WHEN HANDLING FUEL.
•KEEP HEAT, SPARKS, AND FLAME AWAY. •HANDLE FUEL ONLY
OUTDOORS. •WIPE UP SPILLS IMMEDIATELY.
TO PREVENT SERIOUS EYE INJURY, ALWAYS WEAR SAFETY-
GOGGLES OR OTHER EYE PROTECTION WHEN USING COM-
PRESSED AIR.
Remove the carburetor.
Before disassembly, clean the outside of the carburetor.
ASSEMBLY:
Before installing, clean
thoroughly with low-
pressure compressed
air.
SET COLLAR
SEDIMENT CUP
PILOT JET SET
DRAIN SCREW
SET SCREW GASKET
O-RING
MAIN NOZZLE
MAIN JET
FLOAT PIN
ASSEMBLY:
Before installing, clean
thoroughly with low-
pressure compressed
air.
Lightly lubricate the O-
ring to ensure easy
installation into the
carburetor body.
ASSEMBLY:
Before installing, clean
thoroughly with low
compressed air.
FLOAT CHAMBER
O-RING
O-RING
SPRING PIN
(2 x 12 mm)
CHOKE LEVER
FUEL VALVE
PACKING
FUEL VALVE
LEVER
VALVE LEVER
SPRING
LEVER SETTING
PLATE PAN SCREW
(3 x 6 mm) (2)
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as
shown.
DRAIN SCREW GASKET
SET SCREW
UPPER
SIDE
UPPER
SIDE
O-RING
CUP FILTER
FLOAT VALVE SPRING
PILOT SCREW
THROTTLE STOP SCREW
FLOAT
FLOAT VALVE
ADJUSTMENT:
REPLACEMENT:
LIMITER CAP
REMOVAL/
INSTALLATION: