JLG X23J - X700AJ Service Manual - Manual (Page 522)

SECTION 6 - JLG CONTROL SYSTEM
3121448 – JLG Lift – 6-33
FREE A
Ignore this signal
FREE B
Ignore this signal
GENERATOR
ON
The engine is on – The control module receives the signal from the alternator
OFF
The engine is off – The control module doesn’t receive the signal from the
alternator
SJIB GND
ON
The lever on the ground part distributor for moving the jib is activated (X17J only)
OFF
The lever on the ground part distributor for moving the jib is deactivated (X17J
only)
MAIN SUPPLY
ON
The mains power supply is connected – The radio control/remote control battery
charger is active
OFF
The mains power supply is not connected – The radio control/remote control
battery charger is not active
START M.TE
ON
The start engine button on the ground is pressed
OFF
The start engine button on the ground is released
TEMP. MOT ON
Ignore this signal
PRESS. MOT ON
Ignore this signal
START M.EL
ON
The start electric motor button on the ground is pressed
OFF
The start electric motor button on the ground is released
TER/NAV A
ON
Ignore this signal
OFF
Ignore this signal
MICROJIB A
ON
The jib is closed – The control switch is released and line A is closed
OFF
The jib is open – The control switch is pressed and line A is open
MICROJIB B
ON
The jib is closed – The control switch is released and line B is closed
OFF
The jib is open – The control switch is pressed and line B is open
SLC SRC
ON
The basket rotation lever or the basket levelling lever on the distributor in the
basket are activated
OFF
The basket rotation lever or the basket levelling lever on the distributor in the
basket are not activated
SIIIB
ON
The third arm lever on the distributor in the basket is activated
OFF
The third arm lever on the distributor in the basket isn’t activated
EMNAV A
ON
The emergency stop in the basket is released – Line A is closed
OFF
The emergency stop in the basket is pressed – Line A is open
EMNAV B
ON
The emergency stop in the basket is released – Line B is closed
OFF
The emergency stop on the radio control/remote control is pressed – Line B is
open
X17J