JLG X23J - X700AJ Service Manual - Manual (Page 363)

SECTION 3 - CHASSIS & TURNTABLE
3-336 – JLG Lift – 3121448
1. Turn the fuel supply to the OFF position.
2. Loosen hose clamps (3) and disconnect hoses (4).
3. If necessary, remove fuel filter element (5). Refer to
Operations and Maintenance Manual, “Fuel System
Filter - Replace”.
4. Remove bolt (1) and remove fuel filter base (2) from
the mounting bracket.
INSTALLATION PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
1. Ensure that the fuel filter base is clean and free from
damage. If necessary, replace the fuel filter base.
2. Align fuel filter base (2) with the mounting bracket.
Install bolt (1). Tighten the bolt to a torque of 25 N·m
(18 lb ft).
3. If necessary, install a new fuel filter element (6) to
fuel filter base (2). Refer to Operation and Mainte-
nance Manual, “Fuel System Filter - Replace”.
4. Connect hoses (4) and tighten hose clamps (3).
NOTE: Ensure that the hoses do not contact any other
engine components.
5. Turn the fuel supply to the ON position.
6. Remove the air from the fuel system. Refer to Opera-
tion and Maintenance Manual, “Fuel System -
Prime”.