JLG X23J - X700AJ Service Manual User Manual
Page 375
SECTION 3 - CHASSIS & TURNTABLE
3-348
– JLG Lift –
3121448
INSTALLATION PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
3. Install a new O-ring seal (1) to engine oil relief valve
(2).
4. Lubricate engine oil relief valve (2) with clean engine
oil.
5. Install engine oil relief valve (2) into the cylinder
block. Tighten the engine oil relief valve to a torque
of 64 N·m (47 lb ft).
WATER PUMP - REMOVE AND INSTALL
REMOVAL PROCEDURE
Start By:
a. Remove the fan. Refer to Disassembly and
Assembly, “Fan - Remove and Install”.
b. Remove the alternator. Refer to Disassembly
and Assembly, “Alternator - Remove and Install”.
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
CARE MUST BE TAKEN TO ENSURE THAT FLUIDS ARE CON-
TAINED DURING PERFORMANCE OF INSPECTION, MAINTE-
NANCE, TESTING, ADJUSTING AND REPAIR OF THE PRODUCT.
BE PREPARED TO COLLECT THE FLUID WITH SUITABLE CON-
TAINERS BEFORE OPENING ANY COMPARTMENT OR DISASSEM-
BLING ANY COMPONENT CONTAINING FLUIDS. DISPOSE OF ALL
FLUIDS ACCORDING TO LOCAL REGULATIONS AND MANDATES.
1. Drain the coolant from the cooling system into a suit-
able container for storage or disposal. Refer to
Operation and Maintenance Manual, “Cooling Sys-
tem Coolant - Drain” for more information.
2. Loosen the hose clamp and disconnect the hose
(not shown) from the water pump inlet.