JLG X23J - X700AJ Service Manual - Manual (Page 134)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-107
INSTALLATION AND COMMISSIONING
Preparation
Cleaning the slew drive and mounting structure
Wear the following additional protective equipment for
cleaning work:
Face protection
to protect the eyes and face from solvents.
Chemical-resistant protective gloves
to protect hands from aggressive substances.
Check protective gloves for leaks prior to use. Clean the
gloves before pulling them off, store them in a well-venti-
lated location.
Cleaning:
I M P O RTA N T ! O N L Y U S E C O L D S O L V E N T S ( E . G .
WHITE SPIRIT, DIESEL OIL, KALTRYL KEV) THAT
D O N O T C O R R O D E T H E S E A L I N G M A T E R I A L .
ENSURE THAT THE CLEANING AGENT DOES NOT
GET INTO THE SLEW DRIVE. DO NOT USE A HIGH-
PRESSURE CLEANER TO CLEAN THE SLEW DRIVE.
UNSUITABLE TRICHLOROETHYLENE-BASED OR
PERCHLOROETHYLENE-BASED CLEANING AGENTS,
OR OTHER AGGRESSIVE CLEANERS DAMAGE THE
SEAL AND MAY CAUSE BEARING DAMAGE.
Figure 3-185. Do not let cleaning agents get into the
slew drive
Figure 3-186. Cleaning
• When using cleaning agents, ensure adequate ventila-
tion.
• Maintain a strict ban on smoking.
• Remove old grease, dust, and fouling with lint-free
cloths.
• Remove foreign material from the support surface of
the mounting structure (including paint residue, weld-
ing beads, burrs).
• If necessary clean the support surface of the slew
drive.
• Strictly comply with industrial safety regulations.