JLG X23J - X700AJ Service Manual - Manual (Page 372)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-345
3. Remove banjo bolt (5) and remove washers (6) from
the cylinder head.
4. Remove oil line (1) from the engine.
INSTALLATION PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
5. Place oil line (1) on the engine. Ensure that the clip
on the oil line is located below nut (2).
6. Position banjo bolt (3) and new washers (4) onto oil
line (1). Install the banjo bolt and oil line to the cylin-
der block finger tight.