JLG X23J - X700AJ Service Manual - Manual (Page 387)

SECTION 3 - CHASSIS & TURNTABLE
3-360 – JLG Lift – 3121448
ENGINE OIL PRESSURE SWITCH - REMOVE AND
INSTALL
REMOVAL PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS.CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
CARE MUST BE TAKEN TO ENSURE THAT FLUIDS ARE CON-
TAINED DURING PERFORMANCE OF INSPECTION, MAINTE-
NANCE, TESTING, ADJUSTING AND REPAIR OF THE PRODUCT.
BE PREPARED TO COLLECT THE FLUID WITH SUITABLE CON-
TAINERS BEFORE OPENING ANY COMPARTMENT OR DISASSEM-
BLING ANY COMPONENT CONTAINING FLUIDS. DISPOSE OF ALL
FLUIDS ACCORDING TO LOCAL REGULATIONS AND MANDATES.
NOTE: The engine oil pressure switch may be located in the
valve mechanism cover or in the cylinder block.
Refer to Specifications, “Engine Oil Pressure Switch”
for the correct location.
1. Disconnect the harness assembly (not shown) from
engine oil pressure switch (1).
2. If engine oil pressure switch (1) is located in the
valve mechanism cover, remove the engine oil pres-
sure switch from the valve mechanism cover.
3. If engine oil pressure switch (1) is located in the cyl-
inder block follow Steps 3.a through 3.c in order to
remove the engine oil pressure switch.
a. Remove engine oil pressure switch (1) and
adapter (4) as an assembly from oil line (2).
b. Remove washers (3).
c. Remove engine oil pressure switch (1) from
adapter (4).
INSTALLATION PROCEDURE
NOTE: The engine oil pressure switch may be located in the
valve mechanism cover or in the cylinder block.
Refer to Specifications, “Engine Oil Pressure Switch”
for the correct location.
Required Tools
Tool
Part
Number
Part Description Qty
A 21820122
POWERPART
Pipe Sealant
1