JLG X23J - X700AJ Service Manual - Manual (Page 67)

SECTION 3 - CHASSIS & TURNTABLE
3-40 – JLG Lift – 3121448
BECAUSE OF THE VERY TIGHT CLEARANCE, CLEAN THE PARTS
VERYWELL AND GUIDE THE SHAFT CAREFULLY INTO THE
MOTOR HOUSING TO PREVENT IT FROM TILTING.
Figure 3-97.
15. Insert the 6 socket head screws M6x12 (30), grade
8.8 and tighten by a torque wrench, at 10 Nm
torque.
Figure 3-98.
16. Turn the sub assembly upside down on the support.
ROTATE THE TIMING SHAFT (36B) UNTIL THE MARK IS PLACED
ON THE MOTOR AXIS OF SYMMETRY, OIL PORT SIDE.
Figure 3-99.
17. Apply a slight coat of grease on the O-ring seat on
the motor housing (36a).
Figure 3-100.