JLG X23J - X700AJ Service Manual - Manual (Page 209)

SECTION 3 - CHASSIS & TURNTABLE
3-182 – JLG Lift – 3121448
CONTROL BOX REMOVAL/INSTALLATION
Disconnect the control box wires.
When installing, refer to the HARNESS AND TUBE ROUT-
ING (with circuit protector).
CONTROL BOX (Without Circuit Protector)
IGNITION COIL WIRES
STARTER SOLENOID WIRE
FLANGE BOLT (6 x 12 mm) (2)
CONTROL BOX (With Circuit Protector)
CHARGE COIL WIRE
Connection of control box wires are
depending on the application of the
engine, therefore, it does not indicate
those parts in this manual.