JLG X23J - X700AJ Service Manual - Manual (Page 65)

SECTION 3 - CHASSIS & TURNTABLE
3-38 – JLG Lift – 3121448
6. Assemble the O-ring seals (49-50) in their seats in
the valve housing (56).
Figure 3-89.
HYDRAULIC MOTOR REASSEMBLY
7. Place the motor housing (36a) on the support with
the output side upwards. If removed, apply Loctite
542 on the plug (44) and tighten, by a torque
wrench, at 50 Nm torque.
Figure 3-90.
8. Place in the internal cover (31) the back-up ring (32)
and the O-ring seal (33).
INFORMATION
BE CAREFUL TO THE CORRECT DIRECTION OF
ASSEMBLY.
Figure 3-91.
9. Apply a slight coat of grease all over the internal
diameter.
TO AVOID ROTATION OF THE O-RING (33) INTO THE SEAT, DO
NOT APPLY GREASE ON THE EXTERNAL DIAMETER.
Figure 3-92.
10. Place the axial bearing (34).