JLG X23J - X700AJ Service Manual - Manual (Page 395)

SECTION 3 - CHASSIS & TURNTABLE
3-368 – JLG Lift – 3121448
3. Mount it on the servo control and tighten until bot-
tom.
4. Cut to 10mm bolt for the throttle, tighten and tighten
down with nut M6.
5. Orientate the bracket with 2 screws + washer 5/
16X3/4 flat. Removing one at a time to put the thread
lock and pull.
6. Mount the actuator and record it in line, check the
operation with the help of a battery.
7. Wires 2 on the actuator to a sheath L = 250 and a
connector with 2-way super-seel door males. The
red wire on connector (2) and black wire on connec-
tor (1).
3
2
2
1 2