JLG X23J - X700AJ Service Manual - Manual (Page 170)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-143
COVER
COVERFAN COVER REMOVAL/INSTALLATION
Remove the recoil starter.
Remove the auto throttle (If equipped).
Open the harness clip and disconnect the engine stop
switch connector (Without control box type).
When installing, refer to the HARNESS ROUTING.
FAN COVER
ENGINE STOP SWITCH
TUBE CLIP
HARNESS CLIP
FLANGE BOLT
(6 x 12 mm) (6)
REMOVAL:
The fan cover can be removed
with the recoil starter assembly
installed.
GROMMET
(Without engine stop switch type)
TAPPING SCREW
(3 x 6 mm) (2)
0.45 N·m (0.046 kgf·m,
0.33 lbf·ft)