JLG X23J - X700AJ Service Manual - Manual (Page 68)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-41
18. Place the O-ring seal (38) into its seat.
Figure 3-101.
19. Place the distributor plate (39) onto the motor hous-
ing (36a) with the holes lined up.
Figure 3-102.
20. Insert the cardan shaft (37).
Figure 3-103.
21. Apply a slight coat of grease on the O-ring seat of
the gerotor (40).
Figure 3-104.
22. Place the O-ring seal (38) into its seat.
Figure 3-105.
FIND THE AXIS OF SYMMETRY OF THE ROLLER GEROTOR (40)
AND DEFINE THE POSITION WHERE A TOOTH OF THE ROTOR IS