JLG X23J - X700AJ Service Manual - Manual (Page 526)

SECTION 6 - JLG CONTROL SYSTEM
3121448 – JLG Lift – 6-37
SCREEN ERRORS 1
SCREEN ERRORS 2
SCREEN ERRORS 3
ST1 GND Control switch if outrigger no. 1
is on the ground.
ST1 OPEN
700AJ – X23J only Control switch if outrigger no. 1
is open.
ST2 GND Control switch if outrigger no. 2
is on the ground.
ST2 OPEN
700AJ – X23J only Control switch if outrigger no. 2
is open.
ST3 GND Control switch if outrigger no. 3
is on the ground.
ST3 OPEN
700AJ - X23J only Control switch if outrigger no. 3
is open.
ST4 GND Control switch if outrigger no. 4
is on the ground.
ST4 OPEN
700AJ - X23J only Control switch if outrigger no. 4
is open.
ESSICAE Key button for aerial part safeties
by-pass
ESSICCA Key button for ground part
safeties by-pass
EM GROUND Emergency stop switch on the
ground
PHOTO Photocells – Indicates if the
photocells have the same signal
ALL. TEMP
Option reserved
for some markets
External temperature sensor
MICROJIB Control switch if the JIB arm is
perfectly closed
EMNAV Emergency stop switch on
remote control in basket
POSM1
700AJ – X23J only Control switch if outrigger no. 1
is open in “reduced area” position
POSM2
700AJ – X23J only Control switch if outrigger no. 2
is open in “reduced area” position
POSM3
700AJ – X23J only Control switch if outrigger no. 3
is open in “reduced area” position
POSM4
700AJ – X23J only Control switch if outrigger no. 4
is open in “reduced area” position
ACCEL Accelerometers or inclination
sensors in the board
LOAD Load cell
ROTA
700AJ – X23J only Aerial part rotation sensor