JLG X23J - X700AJ Service Manual - Manual (Page 121)

SECTION 3 - CHASSIS & TURNTABLE
3-94 – JLG Lift – 3121448
9. Clean carefully the seal faces (15).
APPLY A THIN OIL FILM ON THE ENTIRE METALLIC FACE OF ONE
OR BOTH SEALS. OIL MUST NOT CONTACT SURFACES OTHER
THAN THE SEALING FACES.
10. Place the hydraulic motor (17) inside the gearbox
housing (10).
11. By using a press push the hydraulic motor (17) against
the shoulder on the gearbox housing (10) until assem-
bling of the unit is complete.
12. Turn the gearbox upside down and, by using pliers,
place the circlip (11) into its seat in the hydraulic motor
(17).
13. Place, correctly, the planet assemblies (9) of the 2nd
reduction in the hydraulic motor’s pin (17).