JLG X23J - X700AJ Service Manual - Manual (Page 173)

SECTION 3 - CHASSIS & TURNTABLE
3-146 – JLG Lift – 3121448
AIR CLEANER REMOVAL/INSTALLATION
Dual element type:
CHOKE CONTROL STAY
SLANT OUT SIDE
NOISE SILENCER
AIR CLEANER
ELBOW SEAL
COLLAR
WASHER BOLT
(6 x 22 mm)
GROMMET
HIGH TENSION CORD
9 N·m (0.9 kgf·m, 6.6 lbf·ft)
REMOVAL/
INSTALLATION:
Remove and install the air
cleaner elbow with the
fuel cock lever in the OFF
position and the choke
lever in the CLOSE
position.
Before installation, clean
the inside of the air
cleaner elbow.
Viewed from air cleaner side
INSTALLATION:
Before installing, check for damage.
Note the installation direction.
BREATHER TUBE
INSTALLATION:
After installing the air cleaner elbow,
insert the breather tube to the hole
of the cylinder head cover as shown.
AIR CLEANER
ELEMENT (PAPER)
WING NUT
BREATHER TUBE
AIR CLEANER
COLLAR (2)
CARBURETOR SPACER
FLANGE NUT (6 mm) (2)
AIR CLEANER ELBOW
AIR CLEANER
ELEMENT (FOAM)
AIR CLEANER
COVER
NUT
(If equipped)
(If equipped)