JLG X23J - X700AJ Service Manual - Manual (Page 274)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-247
INSPECTION
• CRANKSHAFT POSITION (CKP) SENSOR
Measure the resistance between the terminal and the
installation fitting.
• CHARGE COIL
Measure the resistance between the terminals.
• POWER COIL
1. Remove the terminal cover from the connector using
a flat-tip screwdriver.
2. Measure the resistance between the BI and G termi-
nals.
• FUEL CUT SOLENOID COIL
Measure the resistance between the terminals.
Specified resistance 216 - 264 Ω
Specified resistance 3A 1.8 - 2.8 Ω
20A 0.1 - 0.3 Ω
Specified resistance 3.5 - 5.3 Ω
Specified resistance 3.1 - 4.7 Ω