JLG X23J - X700AJ Service Manual - Manual (Page 182)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-155
MANUAL OPERATION A TYPE
Remove the following parts.
1. Air cleaner
2. Muffler
3. Fuel tank
4. Tube clamp
Installation is in the reverse of removal.Adjust the maxi-
mum speed.
INSTALLATION:
Install with the long end
of the spring toward the
control base assy.
Hook the governor spring
to the outer hole of the
governor arm.
CONTROL BASE ASSY.
CABLE HOLDER
REMOTO CABLE
GOVERNOR ARM
GOVERNOR ARM
BOLT
NUT (6 mm)
BOLT (6 x 12 mm) (3)
(If equipped)
(Commercially available)
GOVERNOR SPRING
SCREW (5 x 16 mm)
GOVERNOR ARM
SHAFT
REMOVAL/INSTALLATION:
Pull the carburetor assy. (1) to a
point where the groove (2) of the
throttle arm lines up with the
governor rod (3), and then lift the
governor rod out of the hole of the
throttle arm and unhook the
throttle return spring (4).
GOVERNOR ROD/THROTTLE
RETURN SPRING
(3)
(2)
(1)
(4)
(If equipped)
(If equipped)
SCREW (4 x 6 mm)
(If equipped)
OUTER HOLE