JLG X23J - X700AJ Service Manual - Manual (Page 264)

SECTION 3 - CHASSIS & TURNTABLE
3121448 – JLG Lift – 3-237
REASSEMBLY
11. Insert the starter rope end into the. starter reel and
tie the rope as shown.
12. Wind the rope onto the reel counterclockwise and
hook the starter rope into the cutout of the starter
reel.
13. Wind the starter spring and install it to the starter reel
by aligning the outer hook to the groove of the reel.
14. Apply grease to the spring hook and boss of the
starter case. Align the spring inner hook to the case
claw on the case by turning the reel counterclock-
wise.
15. Install the ratchet spring and ratchet as shown.
Apply grease to the friction spring and inside of the
ratchet guide. Install the spring end f friction plate,
and then install the ratchet guide by aligning the "
∆ "
marks of the ratchet guide with the ratchets. Tighten
the setting screw securely.