Apple Motion 5.1.1 - Manual (Page 809)

Chapter 19 Filters 809
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Edges filter applied
Parameters in the Inspector
•
Intensity: Sets the intensity of the edges.
•
Mix: Sets the percentage of the original image to be blended with the filtered image.
Extrude
Gives an object simulated depth, by creating a front and back side, and then offsetting them and
extruding the edges so they connect.
Note: Because this filter only simulates depth, an object with the Extrude filter applied does not
interact with 3D aspects of Motion.
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Extrude filter applied
Parameters in the Inspector
•
Angle: Sets the angle at which the object is extruded. Drag the onscreen control to adjust its
value in the Canvas.
•
Distance: Sets the distance the object is extruded. Drag the onscreen control to adjust its value
in the Canvas.
•
Clipping: Sets the distance at which the extrusion is clipped.
•
Back Size: Sets the size of the back object, as a proportion of its original size.
•
Face Brightness: Sets a brightness level applied to the face of the object.
•
Front Brightness: Sets a brightness level applied to the front of the object.
•
Back Brightness: Sets a brightness level applied to the back of the object.
67% resize factor