Apple Motion 5.1.1 - Manual (Page 762)

Chapter 19 Filters 762
This filter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image Gradient Blur filter applied
Parameters in the Inspector
•
Point 1: Sets the position of the start point of the gradient. Drag the Point 1 onscreen control
(the lower-left point) to adjust the X and Y position of the blur start point in the Canvas.
•
Point 2: Sets the position of the end point of the gradient. Drag the Point 2 onscreen control
(the upper-right point) to adjust the X and Y position of the blur end point in the Canvas.
•
Amount: Sets the radius of the blur.
•
Crop: Sets whether the object is cropped at its original boundaries.
•
Mix: Sets the percentage of the original image to be blended with the blurred image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
Prism
Blurs and refracts the image as if seen through a prism, creating a rainbow effect.
Original image Prism filter applied
Parameters in the Inspector
•
Amount: Sets the radius of the blur. Drag the arrow onscreen control inward and outward to
adjust the amount (and angle) of the blur in the Canvas.
•
Angle: Sets the angle of refraction. Drag the arrow onscreen control in an arc to adjust the
angle of the blur in the Canvas.
•
Crop: Sets whether the object is cropped at its original boundaries.
•
Mix: Sets the percentage of the original image to be blended with the blurred and
refracted image.
•
Publish OSC: Publishes the filter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see
Final Cut Pro X templates overview on page 385.
67% resize factor