Apple Motion 5.1.1 - Manual (Page 567)

Chapter 15 Replicator 567
m Select the replicator, then press Delete.
The original source layer or layers remain in the project.
Adjust a replicator and cells in the HUD
Display the Replicator HUD and Replicator Cell HUD
When you create a replicator from a source layer, the onscreen pattern is built using the default
parameters in the Replicator Inspector and Replicator Cell Inspector. You can modify the most
important of these parameters in Replicator HUD and the Replicator Cell HUD.
To view the Replicator HUD
m In the Layers list or Timeline, select the replicator.
The HUD appears. If it does not appear, press F7 or D.
To view the Replicator Cell HUD
m In the Layers list or Timeline, select a replicator cell.
The HUD appears. If it does not appear, press F7 or D.
Replicator HUD controls
The Replicator HUD contains frequently used controls necessary to modify the shape and
arrangement of the replicator. These parameters are a subset of the parameters found in the
Replicator Inspector. The HUD also provides quick access to the Opacity and Blend Mode
parameters, located in the Properties Inspector.
67% resize factor