Apple Motion 5.1.1 - Manual (Page 555)

Chapter 14 Particles 555
6 Select the “Spark12” cell in the Layers list, then set the Scale slider in the Inspector to 45%.
The resulting image should look approximately like this:
Note: If necessary, disable the original “Spark12” source layer.
7 Next, change the color of the particles generated by the “Spark12” cell by doing the following:
a Choose Colorize from the Color Mode pop-up menu.
b Click the color well in the Color section of the Inspector and choose a light red color in the
Colors window.
c Close the Colors window.
All particles generated by that cell are now red.
8 Use the Opacity Over Life control to make this cell’s particles fade out over their life.
9 To make the spark particles spin as they move away, set the Spin parameter value to 60.
10 In the Layers list, select the “Flare01” cell of the particle system. Its parameters appear in
the Inspector.
11 Follow the procedure in Step 7 to make these particles light yellow.
67% resize factor