TOHO ELECTRONICS TTM200 - Manual (Page 90)

48-7009-E 5-20
5.3.8 How to set MD/READY
★ Start of control (RUN) or stop of control (READY) is selected.
Switchover of RUN/READY can be executed through the key operation with the FUNC key assigned,
or through optional digital (DI) input or communication function.
① Setting with the function key
★
☆
For constant value run mode screen:
PV value (present value)
SV value (target value)
Hold MODE key pressed for 2 seconds.
Input 1 setting screen
Each set screen
Each setting mode
Press the ▲ key twice. Press it, however, once for TTM-204.
Key function setting screen
Press MODE key.
S03-1 Function key 1 function setting screen
Each set screen
Each setting mode
* The function key functions are set in this screen.
For content of key functions, see the function key function assignment table on page 4-21.
* The number displayed in the screen is coincident with that listed in the assignment table.
* Use the ▲/▼ key for setting the numbers.
* The value is set at “00” at factory shipment.
* To be set as follows: ★ = Time of holding the function key pressed and ☆ = 2 (control
start/control stop).
★ = 0: None, 1: 1 second, 2: 2 seconds, 3: 3 seconds, 4: 4 seconds and 5: 5 seconds
* Use the MODE key to move the screen for the setting screen to set the function keys 2 to 5.
The screens change in sequence each time when the MODE key is pressed.
(Note that only the function key 1 is available for TTM-204.)
* The above operations determine the setting of the function (FUNC) key to be the control start (RUN) and control
stop (READY).
* Pressing the function (FUNC) key in the operating mode screen results in operations of RUN and READY.
* Any function key can be assigned for RUN or READY on all equipment models except TTM-204.
* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.
* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode screen.
H
o
ld
MOD
E
k
ey
p
re
ss
ed
fo
r
2
se
co
n
d
s.
For program run mode screen:
PV value (present value)
SV value (PRoG)
Hold MODE key pressed for 2 seconds.
Setting mode is the same as that for Hereinafter,
to the input 1 setting screen similarly to that for
the constant value run mode