TOHO ELECTRONICS TTM200 - Manual (Page 87)

48-7009-E 5-17
5.3.6 Excessive ascent prevention unit (alarm unit) setting
★ Setting for the excessive ascent prevention unit
Setting to use the OUT 1 (output 1) as the excessive ascent prevention unit in constant value run mode
Hold MODE key pressed for 2 seconds.
Constant value run mode screen
PV value (present value)
SV value (target value)
Press the ▲ key four times. Press it, however, three times for TTM-204.
Input 1 setting screen
Each set screen
Each setting mode
OUT 1(output 1) setting screen
H
o
ld
MOD
E
k
ey
p
re
ss
ed
fo
r
2
se
co
n
d
s.
Each set screen
Each setting mode
Press MODE key once.
S05-1 Target connection selection screen
* Target connection is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “0” at factory shipment.
Changing the setting from “0” to “2” results in the event output.
S05-2 Event function 1 setting screen
Press MODE key once.
Press MODE key once.
* Event function is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “000” at factory shipment.
Set the screen “006” or “016” for the use of the excessive ascent prevention unit
(alarm unit). In case of the setting of “016,” the displayed value may exceed the
target value, and it stays as is even when it decreases below the target value.
The setting is reset by turning on the power again.
S05-3 Event upper limit setting mode
* Event upper limit is set in this screen.
* Use the ▲/▼ key for the setting.
* The value is set at “0” at factory shipment.
Set a specific target value.
* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.
* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode
screen.