TOHO ELECTRONICS TTM200 - Manual (Page 220)

48-7009-E 6-72
6.12 Bank function setting
■ Banks 1 to 16 setting
SEt20
bNK
Setting content Initial value
1 bNK01
Parameters for SEt 01 to SEt 17
cNT
2 bNK02 oFF
3 bNK03 oFF
4 bNK04 oFF
5 bNK05 oFF
6 bNK06 oFF
7 bNK07 oFF
8 bNK08 oFF
9 bNK09 oFF
10 bNK10 oFF
11 bNK11 oFF
12 bNK12 oFF
13 bNK13 oFF
14 bNK14 oFF
15 bNK15 oFF
16 bNK16 oFF
Max. 16 of any parameter setting value can be changed in the banks 0 to 7.
For the no use of the bank, set the setting to “OFF.”
When the bank function is set, the bank Nos. 0 to 7 are displayed in the bank display section.
Ｔ Ｔ Ｍ－２ ０ ４
ＳＶ
ＰＶ
Note Parameters with which no bank function is selectable are listed below. Take care that no screen is displayed.
(1) Bank switchover of the control setting mode (SET 04)
(2) All parameters in the initial value setting mode (SET 18)
(3) All parameters in the priority screen design mode (SET 19)
(4) All parameters in the bank setting mode (SET 20)
(5) All parameters of Program Function Setting (SET 21) 3
(6) All parameters of Program Setting (SET 22) 3
(7) All parameters of Bank Auto-Switch Function Setting (SET 23) 3
(8) Some parameters are not selectable, depending on ordered models.
Bank display