TOHO ELECTRONICS TTM200 - Manual (Page 160)

48-7009-E 6-12
6.3 Function key function setting
■ Function settings for function keys 1 to 5
SEt03
KEY
Setting content Initial value
1
to
5
FU1 to FU5
Press the MODE key for making a setting effective.
00
Function settings
*0 No function
*1 Digit shift
*2
Follow the Set21 C/P Operatioin Type Setting
＜Constant Operation Mode＞
Control Mode (MD) / Control Stop (RdY)
＜Program Mode＞ 3
Program Start / Stop
*3 AT start/AT stop
*4 Timer start/reset
*5 Screen reverse feed
*6 ENT
*7 Bank switchover
*8 Control mode/manual
*9 SV/MV Display Switchover 3
*A Constant Operation Mode / Program Mode switchover 3
*b Step Forward 3
*C Pause 3
*d
＜For Program Operation Mode Only＞ 3
SET 22 Call-out Function (SET 22 Short-cut)
Pressing time setting
0* None
1* Pressing time 1 second
2* Pressing time 2 seconds
3* Pressing time 3 seconds
4* Pressing time 4 seconds
5* Pressing time 5 seconds
Set functions for the function keys 1 to 5
(1) Digit shift
The digit shifts each time when the FUNC key is pressed: 1

10

100

1000

1.
Thereby, changes of setting values can be executed with ease.
(2) Control mode/control stop
Pressing the FUNC key results in changing the modes from control mode to control stop or vice versa.
(3) AT start/AT stop
The FUNC key is set to the auto-tuning start/stop key during the PID control.
(4) Timer start/reset
The FUNC key is set to the start/reset key when the timers 1 - 3 setting mode is set for manual start, as well as to the restart/reset
key when a timer operation is once terminated.
(5) Screen reverse feed
Press the FUNC key when feeding a screen back to the one desired to display when it is passed beyond. (Reverse feed)
Note Take care that the reverse feed of SET 18 is not possible.