TOHO ELECTRONICS TTM200 - Manual (Page 124)

48-7009-E 5-54
*5: Bank setting (St*bK)
Switchover is made for each step of a program. “Bank No.” can be designated.
Setting range: St*bK = 0 to 7 (The range depends on SET 4 bANKH.)
Initial value: St* bK = 0 (* = 1 to 8)
Note The symbol “*” of the parameter setting display “St*bK” indicates “step No.”
(The range depends on SET 22 StEPN.)
Note Effective only during a program run
Note When the bank automatic switching function is used (SET 23 BAF

1), no display
appears. The bank automatic switching function is prioritized over the “bank No.”
designation.
*6: Step time (tIM*)
Sets the step time of a program.
Setting range: tIM* = 00:00 to 99:59 Initial value: 00:00 to (* = 1 to 8)
Note The symbol “*” of the parameter setting display “tIM*” indicates “step No.”
(The range depends on SET 22 StEPN.)
Note The time unit is set in the time unit setting (SET 21 H/MP).
Note With the setting value of “00:00,” a run unlimitedly continues.