TOHO ELECTRONICS TTM200 - Manual (Page 147)

48-7009-E 5-77
■ Regarding the “bank function” priority
If multiple settings are set for the bank switching designation, bank switching is applied from of a
function with a higher priority.
The following applies (“1” is of the highest priority).
1. “Bank automatic switching function”
SET 23 [PM*] zone threshold* setting (“*”: Zone No.)
2. “Program run”
SET 22 [St*bK] step* designated bank setting (“*”: Step No.)
3. “Switching with DI”
SET 13 DIF

**** (when “*”

1)
4. “Switching with the function key”
SET 3 FU*

7 (“*”: Key No.)
5. “Setting value of SET 4 bBNK”
bBNK

* (“*”: Bank value)
Note Note that, if multiple designations of 1 to 5 above are set, the designation with a lower priority is
disregarded.