ADTRAN 1000R Series - Manual (Page 96)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 96
debug atm oam loopback [end-to-end | segment]
Use the debug atm oam command to display Operation, Administration, and Maintenance (OAM) packets
for an ATM virtual circuit descriptor (VCD). Debug messages are displayed (real time) to the terminal (or
Telnet) screen. Use the no form of this command to disable debug messages.
Variations of this command include the following:
debug atm oam
debug atm oam loopback [end-to-end | segment]
debug atm oam loopback [end-to-end | segment]
Syntax Description
Shows OAM packets for a specific VCD.
loopback Configures an OAM loopback.
end-to-end Configures an end-to-end OAM loopback.
segment Configures a segment loopback.
Specifies 16-byte OAM loopback location ID (LLID).
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following example activates ATM OAM debug messages for VCD 1:
>enable
#debug atm oam 1