ADTRAN 1000R Series - Manual (Page 336)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 336
aaa authorization commands [ | default] [group
| group tacacs+ | if-authenticated | none]
Use aaa authorization commands to create (or change) a list of methods for user authorization. For more
detailed information on AAA functionality, refer to the Technology Review section of the command aaa on
on page 340 .
Syntax Description
Specifies the commands enable level. (1=unprivileged, 15 = privileged).
Specifies the name of the authorization list.
default Specifies the default authorization list and applies it implicitly across all lines.
group Uses the specified group of remote servers for authorization.
group tacacs+ Uses all defined TACACS+ servers for authorization.
if-authenticated Succeeds if user has authenticated.
none Access automatically granted.
Default Values
The authorization list named default is the default list used to authorize commands when no other list is
assigned to the line.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following command creates a list called myList to authorize unprivileged commands (which succeeds
only if the user has been authenticated successfully):
(config)#aaa authorization commands 1 myList if-authenticated
The following command uses the default list to authorize privileged (level 15) commands against the
defined TACACS+ servers:
(config)#aaa authorization commands 15 default group tacacs+