ADTRAN 1000R Series - Manual (Page 732)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 732
dial-backup connect-timeout
Use the dial-backup connect-timeout command to specify the number of seconds to wait for a connection
after a call is attempted before trying to call again or dialing a different number. It is recommended this
number be greater than 60.
Syntax Description
Specifies the amount of time (in seconds) that the router will wait for a connection
before attempting another call (valid range: 10 to 300).
Default Values
By default, the dial-backup connect-timeout period is set to 60 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example configures the AOS to wait 120 seconds before retrying a failed dial-backup call:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup connect-timeout 120