Clear ip policy-sessions – ADTRAN 1000R Series User Manual

Page 60

Command Reference Guide

Enable Mode Command Set

61200510L1-35E

clear ip policy-sessions

Use the clear ip policy-sessions command to clear policy class sessions. You may clear all the sessions or
a specific session. Use the show ip policy-sessions command to view a current session listing. The
following lists the complete syntax for the clear ip policy-sessions commands:

clear ip policy-sessions

clear ip policy-sessions [ahp | esp | gre | icmp | tcp | udp | ]

[destination | source]

Syntax Description

Alphanumeric descriptor for identifying the configured access policy (access
policy descriptors are not case-sensitive).

ahp

Specifies authentication header protocol (AHP).

esp Specifies

encapsulating

security payload protocol (ESP).

gre

Specifies general routing encapsulation protocol (GRE).

icmp

Specifies Internet control message protocol (ICMP) protocol.

tcp Specifies

transmission

control protocol (TCP).

udp

Specifies universal datagram protocol (UDP).

Specifies protocol (valid range: 0 to 255).

Specifies the source IP address (format is A.B.C.D).

Specifies the source port (in hex format AHP, ESP, and GRE; decimal for all other
protocols).

Specifies the destination IP address (format is A.B.C.D).

Specifies the destination port (in hex format for AHP, ESP, and GRE; decimal for
all other protocols).

[destination | source] For NAT sessions, this specifies whether to select a NAT source or NAT

destination session.

For NAT sessions, this specifies the NAT IP address (format is A.B.C.D).

For NAT sessions, this specifies the NAT port (in hex format for AHP, ESP, and
GRE; decimal for all other protocols).

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.