ADTRAN 1000R Series - Manual (Page 166)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 166
show channel-group
Use the show channel-group command to display detailed information regarding port aggregation of a
specified channel group (i.e., channel groups and their associated ports).
Variations of this command include the following:
show channel-group port-channel load-balance
show channel-group summary
show channel-group summary
Syntax Description
port-channel load-balance Displays the current load-balance scheme.
summary Summarizes the state of all channel groups or of a specific channel group (if
specified by the argument).
Specifies the channel group using the channel group ID (16).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is a sample from the show channel-group command:
>enable
#show channel-group summary
Channel Group Port channel Associated Ports
-------------------- ----------------- -----------------------
1 1 eth 0/2 eth 0/3
2 2 eth 0/5 eth 0/6 eth 0/7